14
May
Once the cup is seated and straight in the yoke hammer the yoke home and install the C-clip or snap ring. Remove U-Joints without a Press 5 min.
I start out by using a bench grinder with a wire wheel on it and clean the outside of the yokes where the snap rings are.
U joint removal. Remove U-Joints without a Press 5 min. U-Joint Removal - YouTube. Mightytower41a h en 30.
To remove the old caps and ujoint. I start out by using a bench grinder with a wire wheel on it and clean the outside of the yokes where the snap rings are. This removes the dirt and rust from the snap ring and makes it easier to remove.
5172021 if ordered today 8799. 5172021 if ordered today Add To Cart. OEMTools 27310 - OEMToolsU-Joint Removal.
Secure two opposing cups to the new U-joint with a rubber band or tape and remove the two other cups carefully and slide the polished ends of the U-joint into the yoke openings. Place a bearing cup under one of these openings and tap the yoke to seat the cup. Once the cup is seated and straight in the yoke hammer the yoke home and install the C-clip or snap ring.
Repeat on the opposite site. The first step in replacing your u-joint is getting at it. To do this youll need to remove the drive shaft.
On some vehicles you remove the drive shaft by removing the universal joint. If your vehicle is like this follow the instructions that follow and your driveshaft will drop. A vise is used to remove the u-joint by pressing the bearing cups out.
A small socket is positioned over one bearing cap use a socket just slightly smaller than the diameter of the bearing cap and a larger socket is placed over the opposite bearing cap to receive the cap as it is pressed out of the yoke by tightening the vise. Remove the U bolts then slide the driveshaft forward into the transmission with a large screwdriver. It should slide forward enough to drop clear of the pinion yoke.
2 Remove the internalexternal C-clips or press out the injected ring of polymer holding the U joints in place. Wout U-Joint Pullers Bearing-Cup Removal Tool - Heavy Duty Universal Joint Puller Automotive U Joint Drive Shaft Disassembly Tool Class 1-3 5399. Get it as soon as Thu Apr 29.
FREE Shipping by Amazon. Only 4 left in stock - order soon. 4 in 1 Ball Press U Joint Heavy Duty Removal Tool Set Kit 4x4 Adapters 2wd 4wd.
45 out of 5 stars. - 4 in 1 Ball Press U Joint Heavy Duty Removal Tool Set Kit 4x4 Adapters 2wd 4wd. As you can see since the socket is inside of the yoke opening it will serve as a guide for the u-joint tool and keep the large opening centered over the yoke hole.
Then as you push the u-joint in from the right hand side the socket will push itself out through the opening in the u-joint tool.